I changed the S value to 1 on the M569 P0.4 line in order to get the filament extruded but I must admit that I was surprised I had to do this, as it was working fine with the previous motor, so maybe that the hemera motor is setup to turn in the other direction, this is the only thing I can think of right now. M906 X800 Y800 Z800 E800 I30 set motor currents (mA) and motor idle factor in per cent The mount for the Hemera should be printed. M566 X900.00 Y900.00 Z12.00 E300.00 set maximum instantaneous speed changes (mm/min) The mount for the Hemera should be printed with a very strong plastic. We can also get the current steps per unit with the M503 command. Nominal steps per mm (x16): 397 Recommended current: 1.4A Peak (0.99 RMS) Filament diameter: 1.75mm Mass (Direct): 290 grams (Including V6 hotside) Direct Drive Dimensions. If its not, calibrate e steps per mm using the following formula until you consistently. Beside the steps is a knee wall with two tiers and cap molding in the style of the. If you don’t, they will be reset to the previous values when the printer shuts down. Mount for E3D Hemera for Ender 5/Linear Bearing Wheel Mount. Use three fasteners per 10 piece and four fasteners per 20 piece. Send the M500 command if you want to save these settings to EEPROM. M92 X80.00 Y80.00 Z800.00 E409 set steps per mm For example, sending G92 X100 Y100 will set both the X and Y axes to 100 steps/mm. M350 X16 Y16 Z16 E16 I1 configure microstepping with interpolation M569 P0.4 S1 physical drive 0.4 goes backwards M569 P0.2 S0 physical drive 0.2 goes backwards M569 P0.1 S0 physical drive 0.1 goes backwards M569 P0.0 S0 physical drive 0.0 goes backwards I believe the changes on config.g to be correct but I'm clearly missing something or my Hemera is faulty: When sending a G1 E100 F3000 command in the console I just get about 4,5mm extruded. Firmware modification is not an optional step, in order for your Hemera unit to work effectively you must make the. Nominal steps per mm (16x): 409 steps per mm (further calibration required) Motor current: 1.33A Filament diameter and tolerances: 1.75☐. I'm having an issue on my Ender 5 Plus when trying to calibrate the extrusion following the replacement of a Microswiss hotend with a Hemera, I'm using a Duet 3 board the normal one not the mini.
0 Comments
Leave a Reply. |