before it has cured, the contaminants may interfere with or imbed in the protective film. This stuff works great, still looks clean and shiny after being exposed to rain and spray. If the coating is exposed to contaminants such as oil, fuel, soot, hard water, tree sap, cleaners, etc. Review: Goes on easy, but a little hard to remove the haze. Great Great I also use it on the hulls of my R/C sailboats. The polymer film - less than a micron thick - helps prevent stains and adhe. Review: On my first use of RejeX, I finished wiping the hood and tossed the rag onto the hood and it slid right off. It is important to allow RejeX to cure for 8-12 hours after the haze has been wiped off. RejeX is an advanced polymer treatment - not merely a wax or polish - that seals and protects cars, trucks, motorcycles, RVs, off-road vehicles and. RejeX is a thin-film polymer coating designed to provide a high-release finish. Curing is required to allow the monomers (polymer building blocks) that make up RejeX to attach to the surface being treated and to crosslink into a crystal-clear, impervious film. RejeX is wiped on, allowed to dry to a haze for approximately 20 minutes, wiped off, then allowed to cure for 8-12 hours (depending on the humidity the higher the humidity, the faster the cure). ![]() If the surface is too hot, the coating can cure before it has properly bonded to the surface, so it may not perform up to its potential. When over 85° F, be sure to apply RejeX out of direct sunlight. Ideally, RejeX should be applied to a cool, dry, clean surface. Never wax again RejeX shines better and lasts longer than any wax Recently named a Top 10 Boat Care Product of All-Time Superior protection from UV, acids. RejeX contains none of the free silicone oils found in some other products that are known to contaminate paint and cause problems when repainting. RejeX is an advanced polymer treatment not merely a wax or polish that seals and protects cars, trucks, motorcycles, RVs, off-road vehicles and aircraft. It’s easy to apply and produces a deep, lustrous shine that outlasts the most popular waxes by months. ![]() It also makes graffiti easy to remove and can be applied to windshields to repel rain. This very thin film – less than a micron thick – prevents stains and adhesion of common contaminants such as exhaust, bugs, oil, tree sap, bird droppings, road grime, brake dust, etc. RejeX is a thin-film polymer coating designed to provide a high-release protective finish for vehicles of all kinds. The amazing polymer finish that "rejects" UV, bird droppings, bugs splats, brake dust and other contaminants and road grime.
0 Comments
Leave a Reply. |